Solid Carbide Compression Combination Pattern / Flush Trim Router Bit, 2+2 Flute, 1/2" Shank

American Made Quality at Factory Direct Prices 

Pattern routing has three basic rules to ensure your safety and to achieve the best surface finish. 1) Feed into the rotation of the router bit. In general, on a router table that means feeding from your right to your left. 2) Cut downhill on any slope or curve along the edge grain of the wood. 3) Approach corners so you transition from edge grain to end grain rather than end grain to edge grain.  One sure way to guarantee you can follow these rules is to be prepared to work with your pattern both above and below your workpiece. On a simple rectangle as shown in the photos, two opposing corners are cut with the pattern on top. 

The other two opposing corners are cut with the pattern on the bottom. Just flip your project over, raise the bit until the shaft-side bearing engages the pattern and get right back to work. You'll get flawless cuts on all four quadrants with minimal risk of tear-out or catches.

Don’t settle for inferior quality imported bits to save money. Woodpeckers uses state-of-the-art CNC grinding equipment, the highest quality solid carbide blanks and ultra-fine grinding wheels to produce American-made router bits at extremely competitive prices. The days of paying extra for middle-man markups are over. Buy direct from the manufacturer and pocket the savings. 

Like all Woodpeckers products, the Ultra-Shear 3/4" Solid Carbide Compression Pattern and Flush Trim Bit is made right here in our Strongsville, Ohio, facility just south of Cleveland. We’re confident you won’t find an American-made bit of the same design for less.

Do you have a router bit in mind you would like to see in the Ultra-Shear line-up? Tell us about it in an email to mailroom@woodpeck.com.

Note:  The Buy 2 or More Savings is offered when 2 or more of the same Bits are purchased.